How To Fix A Leaking Football Valve

Download Article

Download Commodity

Practice you want to repair your favorite soccer ball after it's been damaged? This article will show you how to get the task done using a few standard supplies. With but a little time and effort, your soccer ball will exist good every bit new!

Steps Download Article

1
Get the necessary tools. The tools you lot'll need are:
- a small flat screwdriver
- circular-tipped pair of scissors
- curved needle
- polyester thread (Gutermann blazon)
- low-cal glue blazon Bostik
- patches and putty for bicycle repair (tube repair kit)
- Needle and thread are readily available at any haberdashery (sewing supply shop) while putty and air chamber repair kits tin can exist found at any hardware shop.
two

Open the flask by cutting the seam thread from the opposite side of the inflation valve. For this operation, the screwdriver will be useful to elevator the sewing thread so as to cut it without damaging the edge of the brawl.

Ad
3

Cutting only the wire and exercise not harm the dowel of the ball. Work carefully. The holes should not be damaged in order to make a perfect rewinding afterwards in the procedure.
four

Deflate the inner tube slightly. Generally it is covered by a polyester thread that is slightly glued to information technology. You'll need to remove it to piece of work on it, information technology is necessary to debunk it every bit much as possible to go far laissez passer through the opening you accept created.
5

Extract the inner tube. The inner tube is glued to the valve block, and it is necessary to use a piddling strength to excerpt information technology.
6

Locate the hole. Inflate the tube and, if necessary, immerse it in a container of water to locate the hole. Lift the outer cover just above the hole, using the pair of scissors to expose it.
7

Repair the inner tube using the repair kit. Scrape the surface of the inner tube with the special grater blade or the abrasive paper in the kit, and then spread the putty of the kit over the hole, wait a few minutes and gum the prepared piece, exerting a homogeneous pressure for a few minutes. Information technology is also possible to maintain a moderate pressure for well-nigh xxx minutes on the applied piece with the help of a clench. If possible, expect 12 hours before inflating the tube to check for perfect seal, and then reposition the outer comprehend and fix it with the Bostik putty.
eight
Paste the inner tube to the airship coating at the inflation valve. To practice this, use the Bostik and wait at to the lowest degree 12 hours until the gluing is firm. This will allow y'all to reinsert the inner tube into the balloon (the outer portion of the ball) without the two detaching.
- Only paste the valves together. Practise not paste any other part of the inner tube to the cover since you may still need to brand adjustments.
9

Inflate the ball to correctly position the inner tube inside. To position the inner tube within correctly, massage the flask and and so deflate information technology slightly (near halfway). Make certain the tube is centered before proceeding.
10

Thread the seam dorsum together. Work advisedly. Centering the tube previously should reduce the take chances of piercing the sleeping accommodation with the needle, but you should notwithstanding work with a steady hand.
11
Sew the brawl cover using the curved needle and the double thread. Use the holes already present.
- Following the diagram shown in the photograph, notation that parte esterna refers to the outside, and parte interna refers to the within.
12

Pull the thread and so that the seam is tightened. Furthermore, no holes should be skipped so that the work is precise and resistant.
13

Inflate the ball to 0.5-0.7 bar. Have fun with your newly repaired soccer brawl!